Preparing a Semiconductor Wafer Specification for Research
Begin a wafer inquiry with the parameters essential to the experiment. Two wafers of the same material and diameter can differ in electrical, surface, crystalline or geometric specification. A grade name alone is not a complete acceptance definition.
Pre-quotation checklist
| Field | How to specify it | Add when required |
|---|---|---|
| Material and structure | Si, GaAs, GaN, SiC or the complete layer structure | GaN template / free-standing substrate, SiC polytype |
| Diameter and thickness | Units and tolerance for each dimension | Length × width for diced pieces |
| Crystal orientation | Surface plane and angular tolerance | Off-cut angle/direction, flat or notch requirement |
| Electrical properties | Conductivity type, dopant; resistivity or carrier requirement | Measurement method, uniformity or report requirement |
| Surface finish | SSP: single-side; DSP: double-side polished | Epi-ready definition, backside treatment, roughness |
| Geometry | TTV, bow and warp limits separate from nominal thickness | Measurement conditions and edge exclusion |
| Coating / oxide | Separate substrate and layer thicknesses | Coated sides, thickness tolerance, process preference |
| Documents and packaging | Requested analysis and measurement records; quantity | Lot/wafer identification, clean packaging |
A material name does not define the wafer structure
For GaN, identify whether you need a substrate, template or epitaxial structure. For SiC, include the polytype and required face information. For thermally oxidized silicon, state silicon thickness and SiO₂ thickness separately, with units for each.
TTV, bow and warp are separate acceptance parameters
TTV expresses the difference between maximum and minimum local thickness under defined measurement conditions. Bow and warp are separate shape parameters. Nominal thickness tolerance does not replace these limits. State the parameters essential to the experiment and the measurement scope required.
Separate mandatory limits, preferences and open questions
State mandatory requirements clearly and identify separately any acceptable alternatives in thickness, grade or surface finish. Confirm the measurement and supply feasibility of special requirements such as minority-carrier lifetime, oxygen/carbon, EPD or metallic contamination before quotation is finalized.
Compare the offered specification with your request
Compare the offered values against the specification line by line. An omitted parameter is not evidence of compliance. Agree measurement reports, lot identification and documents required for acceptance before order, and clarify deviations in writing.
Copyable RFQ specification template
Complete the fields relevant to your experiment; mark unknowns as “technical recommendation requested”. Paste the text into the RFQ technical notes and attach drawings or specifications separately.
Material / structure / layers: Diameter (mm or inch): Substrate thickness and tolerance (µm): Orientation / off-cut / tolerance: Conductivity type and dopant: Resistivity (Ω·cm) or carrier concentration: SSP / DSP and backside treatment: TTV / bow / warp limits: Coating/oxide if applicable: thickness and coated sides: Special defect / impurity / lifetime requirements: Mandatory limits and acceptable alternatives: Quantity, documentation and packaging: